PVC Water Supply Pipe for Borehole Schemes in Ghana: From Pump Discharge to Overhead Tank and Standpipe

A borehole scheme in Ghana is rarely one pipe. Water leaves the submersible pump at seven or eight bar, climbs to an overhead tank through a rising main, then falls to a standpipe at barely half a bar. A PVC water supply pipe sized for one leg is wrong for the next.

Quoted from one pressure class, such a network leaks in two places: at the pump discharge, where surge arrives, and at the tank connection, where vibration meets static head. Reading the scheme as four zones costs nothing on paper and prevents both.

Between pump and tank the PVC-U water pipe carries the highest pressure in the scheme and absorbs the water hammer every time the pump stops. PN16 belongs on this leg; where the pump curve is steep, surge allowance matters more than the class printed on the barrel.

A rising main never rests: a tank thirty metres up adds three bar before any tap opens, and the pipe holds it all day. Solvent-cement sockets, cleaned and primed, are the only joint that belongs here. A push-fit coupler made for drainage has no pressure rating.

Extrusion hall of the G AND N FORTUNE plant with parallel PVC pipe and profile lines running under one roof
Inside the extrusion hall: parallel lines run PVC pipe and profile under one roof, sharing compound intake and first-off inspection before any barrel is bundled.

Below the tank the question changes. Gravity distribution runs at two to four bar, so PN6 or PN10 usually suffices, and velocity becomes the design variable: near one metre per second keeps friction loss down and softens the surge from a fast-closing tap.

Ghana's heat is what temperate specs ignore. Surface runs bake, the pipe expands, and a line clamped hard to a wall buckles at a joint within a season; bury it, shade it, or leave an expansion loop every few lengths. Above ground, a UV-stabilised compound is a requirement.

Most schemes leak first at the tank. A tank connector, a float valve and a short flexible length keep vibration off the tank wall, while an air release at the high point stops vapour locking after a dry run. At the outlet, a reducing tee and a concrete apron keep the branch from settling.

Fittings decide whether it holds. China PVC water supply pipes and their couplers, elbows, tees and reducers must share one socket bore and one wall tolerance, because a coupler moulded to a different figure weeps before the barrel fails. Ask for socket depth and wall tolerance, not only the PN number.

Rows of injection molding machines producing PVC pipe fittings in the G AND N FORTUNE workshop
The injection shop: couplers, elbows, tees and tank connectors moulded in-house against the same drawings as the pipe they join.

G AND N FORTUNE LIMITED runs 35 extrusion lines for pipe and 55 injection molding machines for couplers, elbows and tank connectors in one plant, under British Standard (BS) certification and 20 years of export to Nigeria, Ghana, Saudi Arabia, the UAE, Malta and Thailand. Order by leg and the container arrives matched to the drawing.


Get the latest price? We'll respond as soon as possible(within 12 hours)

Privacy policy